X-Rite 890 Color Process Control Densitometer Instruction Manual download pdf (Page 30)

SECTION FOUR

4-2

3. Measure strip

• For paper strips, adjust the paper guides according to the number

displayed on the screen. If multiple pass, note what color is to be

measured first. Insert strip until it comes to rest against the drive rollers.

• For film strips, note insertion direction and insert strip into the 35mm

slot until it comes to rest against the drive rollers.

• For printer balance strips, note insert direction and center bull’s-eye

over middle diamond. Slide paper guides next to strip and insert strip

until it comes to rest against the drive rollers.

20 30

• The densitometer indicates that processing is taking place and the

measurement status. If a paper strip is measured that has multiple passes,

the display indicates the pass to insert.

PROCESSING...

PASS #1 of 1 OK!

NOTE: If INVALID READING, UNRECOGNIZABLE STRIP, or BUFFER

OVERFLOW messages display after a measurement, re-read strip. If the same

message appears after re-reading strip, refer to Appendix B of this manual.

• Transmitting Data momentarily appears in the display screen (if auto

transmit is enabled in Configuration Options), indicating measurement

data is being transmitted out the I/O port.

TRANSMITTING

DATA

• The instrument screen displays the RGB measurement results. Refer to

next page for procedure to view field results.

r.rr g.gg b.bb

Stain exit

Paper Guide

35mm Slot

Center Diamond

Paper Guide

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 51 52

No comments

X-Rite 890 Color Process Control Densitometer Instruction Manual Page 30