X-Rite PlateScope Calibration Plaque User's Guide download pdf (Page 32)

PLATESCOPE

Replacing the Battery Pack

Use only X-Rite battery pack (NiMH) P/N SE15-38; other types may burst causing personal

injury.

1. Unplug the AC adapter and interface cable from the instrument if connected.

2. Carefully rest the instrument on its side.

3. Remove the two screws securing the battery cover in place.

4. Remove the battery access cover and set aside.

5. Remove the old battery pack and unplug the connector.

6. Plug in the connector with the white wire end towards the back of the instrument.

7. Install the battery into the compartment.

8. Replace the battery cover and secure with the two screws.

9. Charge the new battery pack for 4 hours for a full charge.

Screw (2)

Battery cover

Battery pack

Connector

Red wire

White wire

1 2 ... 27 28 29 30 31 32 33 34 35 36

No comments

X-Rite PlateScope Calibration Plaque User's Guide Page 32