X-Rite 504 SpectroDensitometer Operator's Manual download pdf (Page 26)

CHAPTER TWO

2-6

Selecting from a List

Many settings and functions allow you to select specific

items from a list. Lists can be found in every type of

screen: menus, editor, function screens, etc.

To select an item from a list:

1. Use the Tab keys $@ to highlight the desired item in

the list.

2. Press the Enter key # to save your selection (and

return to the previous screen).

Editing a Value

Many settings and functions allow you to edit specific

values. Values are typically edited in editor screens.

To edit a value:

1. Use the Tab keys $@ to highlighted the desired value.

2. Press the Enter key # to access the menu.

3. Use the Tab keys $@ to choose the desired digit

(arrows above and below designated selection). Press

the Enter key # to access the editor.

4. Use the Tab keys $@ to highlight the desired number

and press the Enter key # to exit the editor.

5. When editing is completed, use the Tab keys $@ to

highlight Save & Exit and press Enter key #.

Important Measurement Techniques

In order for the instrument to obtain accurate and

repeatable measurements, the bottom of the shoe must be

flat with the surface to be measured. When measuring

curved items where a flat surface is not available, a

fixture should be used. A fixture allows accurate

positioning of the sample tangent to the measurement

plane. If the item to be measured is smaller than the shoe,

you may want to make a platform—at same height as the

item—for the rest of the instrument to sit on.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 125 126

No comments

X-Rite 504 SpectroDensitometer Operator's Manual Page 26